Wednesday, February 9, 2011

Flour Paste Resist Tutorial




Here's the promised flour paste tutorial. Put plastic over your surface on which you will be working. This is very messy so lots of plastic, much wider than your fabric. Pin the top edge of the fabric. You can see it in this photo but I have pinned the edge that is closest to the bucket of flour paste. Mix 1 cup cold water and 1 cup flour in a tub. Use cold water as to make the paste a better consistency. For this silk scarf, I used two recipes of flour paste. I forgot to take a photo before I put flour paste on but you get the idea.




  
I just pour the paste straight out of the container on to the fabric. Pour along the top edge where you pinned the fabric down. It takes quite a bit so pour generously (more than this photo).



Then use a squeegee or some flat tool to scrape a layer of flour paste over the entire piece of fabric. This process stretches the fabric and is why you only pin the top edge.
 Here's better photo of a generous pour of flour paste.
 Once you have your entire surface covered with flour paste, pin the bottom edge and ends of fabric. Make sure you have covered all your edges well. I have this on my "new" print table that I made by stapling a large piece of black felt to the table. Therefore, I can pin right through the plastic and into the felt.
 If your table is too low, just add four pieces of PVC pipe. Works a charm to prevent your back from bothering when working.
 Then let the piece dry for at least 24 hours. I had the fan going on this and it only took 12 hours to dry. It should all be the same color with no translucent looking spots when it is dry. If you look closely, you can see that almost all the pins have been pulled up due to shrinkage. If you don't pin it down, the entire piece will curl up and be a big mess. Ask me how I know!!
 This is how stiff it is when the flour paste is dry. This is an 8mm silk scarf - now turned into a flour paste plank.
 Here I am holding the end of the scarf. If you haven't tried this technique, it seems really bizarre.
 Next, you need to crack the flour paste. The more you bend, roll or push on the fabric, the more cracking you will get.
 These are just a few photos showing the cracked flour paste.
 Then you can either use fabric paint or thickened dye. I used Jacquard Textile paint mixed with half water and half paint. Paint over the entire surface making sure that your paint is covering all the flour paste resist.
 Here's a peak on the back after painting. This is about how it will look when you wash it out. If that isn't enough crackling, carefully (you'll get paint all over yourself) crack it some more and add more paint. Let paint dry for 24 hours. Most textile paints are supposed to be heat set but it doesn't work to iron this mess. You could try it on the back but both times I've tried it, the paint was pretty well set after 24 hours dry time. If you're using dye, batch like you normally do.

 Then fill a bucket with cold water. You don't want to put the water directly in the sink because you won't want this flour paste/paint gunk going down your sink. I just rolled the scarf up into a roll and dunked it in the water. It starts loosening almost immediately and you can peel it right off. Just let the gunk settle to the bottom of the bucket.
 Can you see the black stuff peeling off in pieces?
 Here's what it looks like.
 Once you've got as much gunk off as possible, wash with mild detergent in the washing machine. Then iron and you'll have a lovely crackled effect. I just love the look of these. I have to try some more with different colored paint. Don't forget to pour the water and flour paste gunk outside. Do not pour it down your sink unless you have a crush on your plumber!
 Here's a few close ups. Can you see the discharged ammonite?
 Here's another look.
 I get carried away.
Because I really like this effect. I certainly did not come up with this idea and I got all instructions from Jane Dunnewold's latest book. If you give it a try, let me know and show us some photos. If you have any questions, don't hesitate to ask.

10 comments:

Vicki W said...

Fabulous!

WoolenSails said...

Love the tutorial, I have to try this one.
I did buy some fabric from a local show that was made in africa. They use the flour method and sun dried it.

Debbie

Sharne's Bit 'n' Bobs said...

I must give this a go! Thanks for the idae.

geni said...

Wonderful results and great tutorial.
Thank you for sharing!

Donna said...

I have to try this, but maybe I'll wait until summer when I can do it outside. I have Jane's Complex Cloth book. I'm sure it has instructions for this or something similar.

Gina said...

Beautiful results! I've been wanting to try this, have Jane's book, and now have a tutorial .... thanks!

red2white said...

I think I won't be able to resist to try this out - when the summer comes and I can work outside, love, love the minimalistic monochormatic pattern! Thank you so much for sharing!

Linda said...

Ruth, THANK YOU so much. This is an excellent tutorial. I have been planning to buy Jane's book, but keep telling myself not to be so extravagant [I have her Complex Cloth]. I will certainly be looking for it now. You have gone to a lot of trouble to share this, and are to be commended in bucket loads. Again, thank you very much.

Mandy said...

This looks so lovely. I must try this one day for myself.
Thaanks for posting the tutorial.

Mary Beth said...

I can't wait to try this process with my upcoming high school students. What a great way to alter plain cloth in a very enviromentally safe manner. I think they will love the process.